Month: September 2016

Cisco UCS Director 6.0 with Hyperflex integration (Video)

by

Automate Hyperflex with UCS Director 6.0 ! The software is available on the Cisco web site : www.cisco.com/go/software In a short video I will show you a working setup with a HX Cluster and UCS Director 6.0. Not only can you monitor the Hyperflex Cluster, but also configure and automate it with workflows.   Cisco … Read more

Really ? 37 minutes to install Cisco Hyperflex ?

by

Configuring the FI / UCS Manager

This week I went to a customer to install Hyperflex HX240 cluster with 4 nodes. Everything was already racked and stacked.

Hyperflex FI configuration
Hyperflex FI configuration

The first step is to configure the FI’s with ip addresses and a password. Just connect a console cable to the FI and your laptop. It’s easier to setup the FI-A and when the setup is finished then power on the FI-B. The procedure to setup a FI-B  is already described at : http://dcccie.joostvandermade.com/?p=25 

 

 

 

 

You should have the correct Firmware for the FI’s. Via the CLI or GUI you can upgrade the FI to the correct firmware. I prefer GUI although via CLI is also very easy. You can find the Dependencies int the Release Notes of Hyperflex

Read more